The factory settings for user and password are: admin/admin You can then search for the Miniserver in Loxone Config and connect. If both Miniserver and computer are set to DHCP, they will use a .x link-local address.Īlternatively, you can manually assign a static IP address to the Miniserver and computer to enable a direct connection. If there is no DHCP server in your network, or if the Miniserver is connected directly to a PC, link-local addressing via Zeroconf is supported.
The LEDs on the RJ45 port are disabled on the Miniserver Go and are off during operation.Īt first startup with factory settings, the Miniserver is assigned an IP address by the router via DHCP. Once the boot up process is complete, the status LED will be permanently lit. The Miniserver Go starts after the power supply is connected, and will be operational within a few seconds. Via the LAN port the Miniserver is connected to the local network or a WiFi router. Plug the included power supply into the Micro-USB connector. The bracket on the back allows for screw mounting.
#Loxone miniserver setup install
Install the unit in a place where it is protected from water, dirt and possible damage. Up to 30 Extensions can be added to the Miniserver Go via the Link interface to add additional functions such as inputs, outputs or interfaces.ĭatasheet Miniserver Go Table of Contents The LAN interface is used for programming and the integrated web server allows the control of the system via a web interface or the Loxone App.Īn Air Base Extension for connecting devices via Loxone Air wireless technology is already integrated. The replaceable microSD card contains the operating system as well as the user programming and settings. The Loxone Miniserver Go serves as central control unit for all kinds of automation tasks.
0 kommentar(er)
